Outside corners are one of those spots on a building that can make or break the look of your finished exterior. If the starter row isn't installed correctly at the corners, everything that goes on top of it will be off too. That's where the Dodge Hanger Corner series comes in — and it's one of the most useful tools in the Dodge Hanger lineup.
What Are the Dodge Hanger Corner Hangers?
The Dodge Hanger Corner series are outside corner hangers specifically designed to be used alongside other Dodge Hanger products. They sit at the corner of the building and work in tandem with the wall hangers to give you a consistent, level starter row that wraps cleanly around the outside edges.
There are two main corner series: the Dodge Hanger Corner 0 (DHC0) and the Dodge Hanger Corner 15 (DHC15). The number in the name isn't random — it tells you about the installation system each corner is part of.
DHC0: The No Drop Corner
The Dodge Hanger Corner 0 is part of the No Drop System and pairs with the Dodge Hanger Bottom (DHB25 series). It's designed for installations where the sheathing will be installed flush with the bottom of the mudsill — no overhang.
To install, you simply bend the top tab of the DHC0 over and place it on the mudsill at each outside corner. If the mudsill is larger than 1.5 inches, skip bending the tab and attach it directly to the side instead. Lightly hammer the stab tab to hold it in place, then fasten with approved fasteners. From there, the DHB hangers handle the rest of the wall.
DHC15: The Drop System Corner
The Dodge Hanger Corner 15 is built for the Drop System and pairs with either the Dodge Hanger Top Leveler (DHTL15) or the Dodge Hanger Rear (DHR15). This combination is used when you need the sheathing to drop approximately 1 inch below the mudsill.
The DHC15 works the same way as its counterpart — it anchors the corner while the other hangers carry the starter row along the wall. It's available in matching saddle widths (3/8 inch, 1/2 inch, and 5/8 inch) to pair with the DHTL or DHR you're already using.
Why Corners Matter So Much
Corners are reference points. If your corner hangers are installed correctly and your chalk line is snapped accurately between them, every hanger along the wall will follow that line. The result is a starter row that's level, consistent, and perfectly positioned — all the way around the building.
Skipping the corner hangers or improvising at the corners is one of the fastest ways to end up with a wavy, uneven starter row that causes headaches for every subsequent course of siding.
The Simple Rule
Match your corner hanger to your wall hanger system. If you're using DHB (No Drop), use DHC0 corners. If you're using DHTL or DHR (Drop System), use DHC15 corners. Keep the saddle widths consistent across the system, and you'll have a rock-solid foundation for the rest of your exterior.