304 stainless steel fastening hangers that let one person install siding, sheathing, and roof decking — safely, perfectly level, without a second set of hands.
✦ Patented NO DROP SYSTEM®✦ 304 Stainless Steel✦ Made In USA✦ Solo Installation✦ Perfectly Level Every Time✦ Patented NO DROP SYSTEM®✦ 304 Stainless Steel✦ Made In USA✦ Solo Installation✦ Perfectly Level Every Time
The Real Problem
Hanging Siding Alone Isn't Just Hard. It's Dangerous.
Every course means holding a heavy panel dead level while it can slip, drop, or throw your line off. Most crews solve this by burning a second worker on a job one person should be able to run.
One worker holds the panel while another marks and levels it — every single course, every wall.
One slip and the panel drops — onto the ground, a worker, or the panel itself cracks.
Uneven courses mean callbacks, rework, and lost margin on the job.
A full crew gets tied up on work one person could run alone.
The hanger holds the panel in place solo — no second worker needed to hold or mark.
The panel locks onto the hanger. It physically can't fall while you fasten.
Built-in leveling geometry keeps every course dead level, automatically.
One person runs the wall. The rest of the crew works the next task.
The System
One Hanger. Three Moves. Perfectly Level.
No chalk lines, no second worker holding the panel, no guesswork — the hanger does the leveling for you.
01
Hang
Set the hanger onto the wall or roof edge — it locks in place instantly, no clamps or fasteners yet.
02
Level
The hanger's built-in geometry holds your panel dead level automatically — no chalk line, no helper.
03
Fasten
Nail or screw through the hanger into the panel. Pull the tab, move to the next course.
A level and chalk line only mark where the panel should go — you still need a second person to hold it steady while you fasten. Dodge Hangers physically hold and level the panel for you, so one person can do the whole job without drift or slippage.
Yes. The hanger locks onto the wall and holds the panel in place while you fasten through it, so you don't need a second set of hands to hold or level the panel.
We offer the Drop System and No Drop System for sheathing and siding, plus Fascia and No Fascia systems for roof decking, and a version built for out-of-level foundations.
304 stainless steel resists rust and corrosion long-term, which matters most on coastal, high-humidity, or long-life installations where a failed fastener means a callback.
Yes — crews use Dodge Hangers to free up labor on siding and sheathing jobs, since one installer can do work that otherwise needs two.
Choosing a selection results in a full page refresh.
